If you don’t know exactly what a slab leak is, then NWA Plumber will explain it. Fixing the plumbing issue on a slab isn’t that difficult, so we regularly discuss how to fix slab leaks. A slab, of course, is the actual concrete foundation under a building.
Usually, the incoming sewer line and plumbing pipes below the slab are perfectly flat, even if it’s sloped towards the outside. But sometimes, the water pipe will get displaced over the years, and this causes a bulge. This is where the slanted water source leaks into the base and causes the problem. When this happens, the damage is already done. So the first thing you need to do is figure out how big the bulge is, how long it has been there, and what caused the bulge in the first place.
To solve the problem, remove the damaged water pipe and replace it with a new one. This is actually the easiest and fastest solution because you will use the same type of pipe. You don’t need to use the same size pipe; just make sure that it is as large as possible.
Also, make sure that the water source is clean. If it is not clean, the water will always get trapped under the base, and you will be stuck with the same problem again. That’s why you need to keep the water pipe cleaned, and you should also clean the drains and gutter.
For those who want to know how to fix slab leaks, you can also take a look at the slant wall. There are actually some instances where there is an unbroken slant wall. Sometimes the slab has cracked, and the water will leak out through the cracks.
In that case, you will need to dig a small area and place a drain to the hole. Then you can fill that hole with the correct drainage material. And you can also place the slant liner to make sure that the water will flow properly.
After that, you will have to close the drain and replace the wall. Again, you need to do it fast so that it doesn’t get clogged. You don’t want the drain and the wall to stay open for long.
The last thing you need to do is just to ensure that the drain is working. If you have some leaks, then you will see water in the toilet or your shower all the time.
If the drain is blocked, the water will go into the sewer and get trapped in there. When the water starts seeping out, it will cause a big mess and cause problems in the bathroom. You can easily solve this problem by cleaning the drain or by placing some waterproofing material in front of it. After that, you can put a new one.
If your slab leak is big and there is a lot of water trapped in your basement, you may need to call in a contractor. You will have to hire a professional to make sure that everything is fixed correctly.
But what you need to know is that a good contractor will be able to save you a lot of time and money. Most of them can give you a quote for the repairs. And they will be able to tell you how much money it would cost to do the job. So you will be able to find the best deal on the job.
Once you know how to repair slab leaks, you will know how to avoid it in the future. In fact, it is important to know about how to prevent it so that you won’t have to worry about it ever again.
Another thing you need to know about how to repair slab leaks is that there are different types of materials that you can choose from. Some of them include rubberized epoxy, vinyl, and fiberglass. With these materials, you will be able to avoid any leaks.